Filter
Top Products
16
OPERATION
Tab 3, 11
Tab 8, 16 Tab 7, 15 Tab 6, 14 Tab 5, 13 Tab 4, 12
EnglishTab2, 10
To pair additional devices
With the Bluetooth device and the
SoundLink
®
Mobile speaker II both turned on,
press the Bluetooth button on the speaker for
three seconds to make the speaker
discoverable again. Then follow steps 2 - 4 on
this page.
The SoundLink
®
Mobile speaker II memory
can hold up to six paired devices. You can
pair more than six devices, but the memory
will never contain more than six. When the
memory is full with six devices and an
additional device is paired, the least recently
used device is deleted from memory and
replaced by the newly paired device.
Clearing memory
To clear the SoundLink
®
Mobile speaker II
memory of all devices, press and hold the
Bluetooth
®
button on the speaker (about 10
seconds) until you hear a tone.
The SoundLink
®
Mobile speaker II clears all
Bluetooth devices from its memory and then
becomes discoverable.
Adding another source
You can use another audio device, such as
a portable digital music player, with your
SoundLink
®
Mobile speaker II. This requires
using an audio cable with a 3.5 mm plug on
one end to connect with the AUX input on the
SoundLink
®
Mobile speaker II system.
Bruiser_OG.book Page 16 Tuesday, June 26, 2012 10:29 AM