Filter
Top Products
14
OPERATION
Tab 3, 11
Tab 8, 16 Tab 7, 15 Tab 6, 14 Tab 5, 13 Tab 4, 12
EnglishTab2, 10
Control buttons
The control buttons are located on the top of
the speaker.
Pairing with Bluetooth
®
devices
Pairing occurs when two Bluetooth devices
communicate with each other and establish a
connection. A record of information about this
connection is then stored in the memory of
each device. Once you pair a device with the
SoundLink
®
Mobile speaker II, you should not
have to pair it again.
The SoundLink
®
Mobile speaker II can pair
with up to six Bluetooth devices. However, it
can only connect to, and play audio from one
device at a time.
• Press to turn the speaker on or off.
• Press and hold to check the battery level
(see “Checking the battery” on page 18).
• Press to select the source connected to the
(AUX) input. See “Adding another
source” on page 16.
• Press to select the Bluetooth
®
source. The
speaker attempts to connect to the last
paired device. See “Pairing with Bluetooth
®
devices.”
• Press and hold for 3 seconds to set the
speaker to discoverable mode and allow
pairing with another Bluetooth
®
device.
• When a device is connected, press to
disconnect the device. The speaker then
waits for a paired device to connect.
• While the Bluetooth
®
source is selected, if
no device connects within 30 minutes, the
speaker turns itself off.
• Mutes sound from the speaker.
• Plus (+) increases volume, minus (–)
decreases volume. The front panel source
indicator flashes once for each button press.
The indicator flashes twice when maximum
or minimum volume is reached.
Bruiser_OG.book Page 14 Tuesday, June 26, 2012 10:29 AM