- 19 -
SETTING THE CABLE TV MODE
1) With the unit turned off, press the SET button three times to enter the cable configuration
mode.
2) CABL appears on the display. Note: If AIR appears, use the Seek Up/Seek Dn to select
CABL.
3) Press the CH up/down button to select the cable mode (STD/IRC/HRC). (NOTE: If you are not
sure what cable system you have, contact your local cable supplier).
4) When the desired mode is reached, press the PWR button to select, the unit will auto-program
all available channels.
SETTING THE AIR TV MODE
1) With the unit turned off, press the SET button three times to enter the cable configuration
mode.
2) Press the SEEK button to select the AIR mode. AIR appears on the display.
3) When the desired mode is reached, press the PWR button to confirm.
SETTING THE PRESETS (FOR AM AND FM OR TV MODES) (Unit turned on)
1) Turn to the desired channel/broadcast frequency.
2) Press the SET button; the display flashes.
3) Select desired Preset (P1, P2, P3, P4 button).
SETTING THE SPEAKER MODE
1) With power off, press the SET button four times to enter the speaker configuration mode.
″ISP (or ESP) ″ appears on the VFD.
2) Press the seek button to toggle between the ″I SP″ and ″E SP″
3) When the desired mode is reached, press the ON/OFF button.
MESSAGE RECORDING
1) Record
- Record a message by pressing and holding the message button while speaking into the
microphone (LED ON).
- Release the message button (LED Blink).
2) Play
- Press the message button (LED Blink).
3) Erase
- Press the message button twice (LED OFF).
Modes of Operation