Audiovox CE710CR MP3 Player User Manual


 
5
INSTALLATION
Clock Back-up Batteries Installation
1. Open the battery compartment door located at the bottom of the unit.
2. Install two DC1.5V 'AAA' (UM-4) batteries (not included) in the battery compartment following the
polarity markings shown on it.
3. Replace the battery door on the battery compartment.
NOTE: Please disconnect the main power from the unit before replacing the clock back-up
batteries.
WARNING:
Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Only batteries of the same or equivalent type as recommend are to be used.
If the unit is not to be used for an extended period of time, remove the battery.
Do not dispose of batteries in fire, batteries may explode or leak.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
FM Antenna Installation
The FM Antenna Wire is provided in the package.
Please see the illustration below for FM Antenna Wire
installation.
Remote Control
Theremotecontroloperates on one CR2032 battery
(included). To activate the remote control, remove the
insulation tab inserted in the battery compartment.
AC Power
Connect the AC power plug into your household AC power outlet (120VAC/60Hz).
NOTE: This unit is not magnetically shielded and may cause color distortion on the screen of some
TVs or video monitors. To avoid this, you may need to move the unit further away from the TV or
monitor if unnatural color shifts or image distortion occurs.
Connect the FM Antenna Wire to the
antenna terminal at the rear of the main unit