Filter
Top Products
5
8. If the operating time decreases drastically even when the rechargeable nickel-
cadmium batteries are properly recharged, purchase a new set of rechargeable
nickel-cadmium batteries.
9. When charging for the first time or after a long time, playing time may be reduced.
In this case, charge and discharge the batteries several times.
Remark: The battery adapter is used with standard rechargeable batteries.
Rechargeable batteries with the negative side exposed do not require this
adapter.
LISTENING WITH HEADPHONES
Connect the plug of the stereo headphones into
the PHONES (GREEN) socket.
WARNING: To prevent damage to your hearing,
avoid excessive volume levels and listening to
sound for a long period of time when using
headphones.
■ Adjust Volume to the desired level.
HANDLING COMPACT DISCS
This unit is designed to play only compact discs bearing the
identification logo below.
Other discs may not conform to the CD standard and may not play properly.
• Dirty, scratched or warped discs may cause
skipping or noise.
• Handle the disc only by the edges. To keep
the disc clean, do not touch its surface.
• Discs should be stored in their cases after
use to avoid serious scratches.
• Do not expose disc to direct sunlight, high
humidity, high temperatures or dust etc. Pro-
longed exposure to extreme temperatures
can warp the disc.
• Do not stick or write anything on either side
of disc. Sharp writing instruments or the inks
used in some felt-tip pens, may damage the
discs its surface.
Remove the disc
Hold the edge and gently press the center pivot
as illustrated to pick up the disc.
CAUTION: Wait for the disc to stop rotating
before pressing the OPEN button.
NOTE: This unit can play 3" (8cm) single CDs
without an adapter. Do not use a CD single
adapter for these discs.
4
INSERT WITH
THE LABEL
FACING UP.
PRESS THE CLAWS
AT THE CENTER OF
THE DISC CASE.
PRESS THE
DISC GENTLY
TO INSERT IT.
LIFT OUT WITHOUT
TOUCHING THE
RECORDED SURFACE.
INCORRECT
CORRECT
FROM THE CENTER TO THE EDGE
INCORRECT
CHARGING AND USE OF RECHARGEABLE BATTERIES
Rechargeable Battery Operation
This unit can fully recharge specified rechargeable batteries, in approximately 15
hours. The rechargeable batteries (NOT supplied) should be recharged before
they are used for the first time, if they are low in power or they have not been used
for a long period (over 60 days).
1. Open the battery compartment cover and
insert two of the recommended rechargeable
batteries, matching polarity. (1.2V 650mA)
WARNING:
BOTH BATTERIES MUST BE
OF RECHARGEABLE NICKEL-CADMIUM
TYPE, OTHERWISE THE BAT TERIES
MAY EXPLODE OR LEAK.
2. If you are using rechargeable batteries that
do not have the negative side exposed, you
will need to use the rechargeable battery
sleeve that is initially packed in the battery
compartment as shown in Fig. A. Insert one
rechargeable battery into the battery sleeve
by sliding the negative terminal of the battery
into the sleeve as shown in Fig. B.
3. Insert the two "AA" rechargeable nickel-
cadmium batteries (not supplied) into the
battery compartment. The battery with the
rechargeable battery sleeve should be
placed in the slot that holds the charge plate
(this is the slot closest to the center of the
unit) as shown in Fig. C.
4. Close the battery compartment door.
5. Connect the supplied AC adapter's plug to
the AC outlet and insert the DC plug into the
DC input jack on the unit. USE ONLY THE
AC ADAPTER SUPPLIED WITH THE SET
FOR CHARGING. NOTE: The charge
indicator will illuminate.
6. After 15 hours, unplug the AC adapter.
7. CAUTION: DO NOT CHARGE
CONTINUOUSLY FOR 24 HOURS OR
MORE. DOING SO CAN CAUSE THE
PERFORMANCE OF THE
RECHARGEABLE BATTERY TO
DETERIORATE.
RECHARGABLE BATTERY SLEEVE
WITH BATTERY CAUTION SHEET
PACKED BY POLYBAG
FIG (A)
RECHARGABLE
BATTERY SLEEVE
OPEN GAP
MUST BE ON
THE UPPER
SIDE POSITION
FIG (C)
FIG (D)
FIG (B)
CHARGE PLATE
BATTERY
RECHARGABLE
BATTERY SLEEVE
A
C
A
D
A
P
T
O
R
TO
PHONES