Filter
Top Products
17
(al variare del livello del volume) Level = 15
Level = 20
7Hz-95KHz
7Hz-100KHz
Livello di rumore Attenuazione 0dB
Limiti di banda 0Hz-48kHz
-100dBV
Rapporto segnale/rumore 22Hz-22kHz 72dB
Alimentazione: - 230V 50-60Hz oppure 115V
50-60Hz
Potenza di uscita Carico: 8 Ohm
THD + N = 0.1%
54W
(*) Vin : tensione imposta in ingresso all’ingresso Line; Level: livello del volume impostato;
TROUBLESHOOTING
Symptom Cause Remedy
The unit is in STANDBY mode Press the STANDBY button on the front
panel of the unit or the STANDBY button
on the remote controller
Incorrectly plugged power cable Make sure the power cable is correctly
plugged into the unit inlet and into the wall
outlet
Main power switch set on “0” Put the switch on “1”
Display is off
No sound
No response from the unit
Burned-out fuse Contact your Audio Analogue retailer for
fuse check/substitution
Display is off
No response from the unit
Incorrectly connected internal boards Contact your Audio Analogue retailer for
connection check.
Selected source: Line
Faulty or incorrectly signal cables between
Enigma and the audio source
Check cables status and their connection Display is on
No sound
Incorrectly selected source on Enigma Check that the audio source is correctly
selected on Enigma
Selected source: tuner
No sound Enigma is in “Storage” mode Complete storage procedure by pressing
“Store” button on the front panel of the unit
or on the remote controller
It is impossible to tune up any radio station
Faulty or incorrectly plugged antennas Check antennas connections and
disposition (FM antenna has to be
completely unrolled). Try to substitute both
antennas.
No battery/ worn-out battery Place/replace battery (2 ‘AAA’ batteries) Remote controller doesn’t work
You’re standing too far or on an exceeding
angle from the front panel
Get closer to the unit or reduce angle
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.
RICERCA GUASTi
Sintomo Causa Rimedio
Togliere l’apparecchio dallo stato di
standby premendo il tasto STANDBY sul
pannello frontale oppure STANDBY sul
telecomando
Cavo di alimentazione non correttamente
collegato
Controllare che la spina del cavo di rete
sia ben inserita nella presa di rete e che il
cavo sia correttamente inserito nella
vaschetta di rete
Interruttore posteriore in posizione 0 Portare l’interruttore posteriore in
posizione 1
Display spento
Nessun suono
Nessuna risposta ai comandi
Fusibile bruciato Sostituire il fusibile all’interno della
vaschetta di rete