Filter
Top Products
43
Install the Total Remote software to the pocket PC.
Follow the directions and begin entering all of the
remotes that you want to use on your iPod to the
software. The next few directions focus on turning
your television on and off.
On the pocket PC, once the software has been
installed, choose
start – programs – total remote.
Next choose edit – start one shot sampling. Choose
the correct power button which is shown on the
interface.
You will be prompted to hold the remote up to the IR
port which is located on the pocket PC. This is how
the IR signal will be recorded.
After you have recorded the IR signal you need to test
it. This is done by using the IR device which is
included with the Total Remote software.
Once you have verified that the signal works you need
to get the IR signal from the pocket PC to your
computer as a sound file.
Recording the Signal
Take the Total Remote IR device away from the pocket PC
jack (for headphones). Next run a line out cable from the
pocket PC to the line in port or to the microphone. If you
like, you can get a 3.5 mm stereo audio cable to help you