Filter
Top Products
MVP-TDS Table Top Docking Station
7
MVP-TDS Table Docking Station for MVP Panels
Installing an MVP-BP Battery into an MVP-TDS
The MVP-TDS connects directly to a PSN4.4 power supply and provides both power and
communication to docked MVP panel. The MVP-TDS can charge batteries in its own battery
compartments, as well as those within the MVP panel.
1. Raise the rear connector cover to expose the battery compartments and connectors.
2. Slide the MVP-BP into the battery compartment (AMX label up) until the connector makes contact
with the battery pins at the end of the battery slot.
3. Repeat these steps for any additional MVP-BP batteries.
4. The status of the connected batteries are reflected on the panel’s Batteries page and the LEDs on the
docking station.
A completely discharged battery requires one full charge cycle from within battery
compartment #1. Refer to FIG. 2 on page 2 for locations.