Filter
Top Products
Chapter 6
Software Installation
CD Mastering Software installation:
1. Load the CD Mastering Disc onto the DVD±R/RW drive of the
DVD DigiCopier (make sure you set the unit to operate as an
External DVD±R/RW Burner – refer to Chapter 5, page 8).
2. Click on the Install Button to start installation process.
3. Follow the On screen Wizard for installation.
4. Wait for a few seconds to finish the installation.
5. Restart the system when prompted.
6. You may now burn CD or CD disc.
Note: Serial Number or CD key can be found on the CD sleeve if
prompted.
Please read the on-line Help of the software for all the detail
commands and features of the software.
Power CD Software installation
:
1. Place the MPEG II software CD in the DVD±R/RW drive of the
DVD DigiCopier.
(Make sure you set the unit to operate as an
External DVD±R/RW Burner – refer to Chapter 5, page 8).
2. In “My Computer” double click the DVDROM icon.
3. Double click on the Power CD folder then the Setup.exe or just
double click on “Set Up” icon and follow the on screen
messages to load MPEG II software.
4. Serial Number or CD key can be found on the CD
Sleeve if Prompted. (It starts with MV most of the time)
# Click NO for the Diagnostics test.
# DO not loose the CD Sleeve in case you need the CD key
later on for reinstallation of the software.
# Please read the on-line Help of the software for all the
Detail commands and features of the software.
Addonics Technologies – DVD±R/RW DigiCopier Users Guide v1.0
14