Filter
Top Products
Chapter 5
Using DVD DigiCopier as an external DVD±R/RW on your
PC
Installation
# Connect the power cable to the back of the DVD DigiCopier.
# Plug in the Power Cord to the AC Power Source
(+90~+250VAC)
# Connect the Interface cable to the back of the DVD DigiCopier
and the other end to your computer or Notebook interface port.
# Set the switch (S1 on figure 1, page 6) at the back to External
position. Power On the unit at the front to start the DVD
DigiCopier.
# LED Display will now lit at the front, will do a series of check, will
check Firmware version. Once the initiation is completed (about
10 -15 seconds), both the Power light and the External light will
stay lit.
# You are now ready to use the DVD±R/RW drive (the bottom
drive) in the DVD DigiCopier as an external storage device
connected to your computer.
# When the DVD DigiCopier is used on a Computer, Only the
DVD±R/RW drive at the bottom Works. The DVDROM drive at
the top will be DISABLED
Addonics Technologies – DVD±R/RW DigiCopier Users Guide v1.0
9