Filter
Top Products
Firewire interface cable installation
Attach the Firewire interface cable to the computer connector (C2, figure
1 on Page 6) at the back of the DVD DigiCopier firm and securely – you
should not be able to disconnect the cable without pressing the release
notch.
Firewire DVD DigiCopier Installation
For Win98SE, Me, 2000 and XP
Note for Win98SE only: After plugging in the cable some system
might prompt you for Win98SE CD, in case you don’t have The Win98SE
CD and the wizard prompt you for:
NTMAP.SYS please type C:\WINDOWS\SYSTEM32\DRIVERS
NTMAPHLP.PDR please type C:\WINDOWS\SYSTEM\IOSUBSYS
IF the system did not prompt you for anything just follow the steps below
1. Make sure the Firewire cable is securely attach from the back of the
drive.
2. Make sure that power is attached and turned on.
3. Power on the system. On the Window Desktop, double click on the
MY COMPUTER icon.
4. Plug the Addonics Six Pin FIREWIRE-IDE cable into your
computer’s FIREWIRE
5. Wait for a few seconds, your computer may blink for a moment as
well.
6. Double Click on the “My Computer” icon if not open yet. Your
DVD DigiCopier will appear as a DVD drive icon.
You are now ready to use the DVD±R/RW drive in the DigiCopier.
Addonics Technologies – DVD±R/RW DigiCopier Users Guide v1.0
12