Filter
Top Products
Cheetah Gigabit Adapter
13
Local Tests
These tests can be used to test the basic functions of the
adapter. Select the “Run Loopback Tests” and “Run Internal
Tests” check boxes either together or separately. The tests to
be performed will show “Ready” as the status in the test list
box. Then click on the “Run Local Tests” button to start the
tests. The progress of each test is shown by the “Test
Progress” status bar. When the tests are complete, click on
the “View Test Results” button to display the test results.
Send and Receive Test
This test verifies that the network cable is connected
correctly, so that the network card can transmit and receive
data.
The test requires two computers with the Cheetah Gigabit
Adapter installed. One computer generates and sends test
messages, the other computer receives the test messages
and transmits them back to the sender.
Note: You should run the Local Tests before running the Send and Receive
Test to ensure that the card’s basic functions are working properly.
To run the test, on one computer be sure the configuration
utility is running to enable it as the receiver. On the other
computer, simply click on the “Run” button to start sending
test messages. The progress of the test is shown by the
“Server Activity” status bar. You can view the test results by
clicking on the “View Test Results” button.