Filter
Top Products
15
3M
™
Digital Media System 800 Series
© 3M 2007. All Rights Reserved.
ENGLISH
Installation and System Setup
13. (Digital Media System 815 Only) Attach the
Annotation Pod as shown on pages 8–9 of the
Digital Media System 815 eBeam
™
Software for
Interactive Whiteboard Operator’s Guide.
14. Start up the projector by switching on the main
power switch, then pressing the power button on
the projector, the control panel or the remote.
Main Power Switch Power Button
15. Adjust the projector arm length to achieve the
desired image size. Extend the section of the
arm closest to the base first by loosening the
clamp, sliding the arm out, and tightening the
clamp. Extend the second section of the arm as
needed.
16. Focus the image by turning the projection
focus ring.
Extend this section first
Extend this section last
Projection Focus Ring
17. To adjust the position of the image on the
screen, refer to the Digital Media System 800
Series Image Alignment Guide.
18. To remove the projector from the wall, remove
the right speaker grill and pull the locking
ring out. Carefully lift the projector off the
mounting plate.
Note: The locking ring may be temporarily retained
in the unlocked position by sliding it into the recess
in the corner of the speaker housing.