61
Storing and Reading Data
A data card can hold up to 99 sets of bulk data, within the limits of
actually available capacity.
• If the indication "noCArd" appears, the data card is not
recognized. Check whether the card has been inserted properly.
• If the indication "Cd Err" appears, there is a problem with the
data card. Format the card again.
• If the source of the last loaded bulk data was a data card, the
original file number will appear. Otherwise a new file number will
be shown.
When the number of an already stored file is selected, the display
flashes.
Bulk data (all waveform data, pad parameter settings, song data for
internal sequencer) are saved to the data card. The ST-224 then
returns to the regular play mode.
• If the indication "Cd FULL" appears after step 3, the
data card does not have enough free capacity. Erase
bulk data that are no longer needed. If the indication
"Cd Err" appears, the data card is defective. Format the
card again.
• When the number of a file where data are already
stored is selected, the display flashes.
• During storing, all currently playing pads are stopped
(including the [SOURCE] pad).
