Commands and Queries Reference Alphabetical reference
VSET program the voltage limiting of the Power Module’s output.
Syntax VSET <ch>,<value>
Parameters the number of the Power Module to be programmed.
the value to be set as the Power Module’s load
voltage limit. The lower limit of the programmed
value is 0. The upper limit of the programmed value
is the lower of VLIM and OVSET. If auto-polarity is
enabled, negative output values can be programmed
by preceding the value with a minus sigh.
Category Settings Type: Overlapped
VSET? return the current programmed value of the Power Module’s load
voltage limit.
Syntax VSET? <ch>
Parameters the number of the channel to be queried.
Category Settings Type: Sequential
WHIGH enable / disable window upper limits checks by the Power Module.
Syntax WHIGH <ch>,<int>
Parameters the number of the Power Module to be programmed.
a value of “0” disables and a value of “1” enables
the Power Module’s upper limit window checks.
Category Warnings Type: Sequential
WHIGH? return the state of the Power Module’s upper window check enable
flag. Result is “0” if disabled and “1” if enabled.
Syntax WHIGH? <ch>
Parameters the number of the channel to be queried.
Category Warnings Type: Sequential
WLOW enable / disable window lower limits checks by the Power Module.
Syntax WLOW <ch>,<int>
Parameters the number of the Power Module to be programmed.
a value of “0” disables and a value of “1” enables
the Power Module’s lower limit window checks.
Category Warnings Type: Sequential
WLOW? return the state of the Power Module’s lower window check enable
flag. Result is “0” if disabled and “1” if enabled.
Syntax WLOW? <ch>
Parameters the number of the channel to be queried.
Category Warnings Type: Sequential
XMP 2600 Programming Manual
rev. 1.1 67
