Vulcan Materials GTS12-4R Manual

A SERVICE OF

next previous

-

9 -

ASSEMBLY

Griddle Top

Assembly Mounting Points

Prior to assembly, make sure the

mounting bracket is the correct size. The

back bracket should match the width of

the griddle.

Make sure the griddle top

electrical specifications match the

available service. Each griddle top will

require its own separate electrical service.

1.

Using (2) washers and (2) ¼”-

28 bolts,

assemble one of the side mount

brackets to the back bracket as

shown

in Fig. 1. The bolts should be hand

tightened only at this point. Repeat

procedure to attach the other side

mount bracket to the other end of the

back bracket.

2. The entire mounting bracket system

should be assembled at this point as

shown in F

ig. 2 with bolts hand

tightened only.

3. Slide mounting bracket system onto

back of the griddle as shown in Fig. 3.

The left and right side brackets should

be pushed up until stopped by the

bottom of the griddle and pushed

forward un

til stopped by the griddle

back panel. Secure the mounting

bracket system at this location with a

“F” clamp on each side of the assembly

as shown. Place a wood block or other

type of protection between clamp and

griddle plate.

Fig. 1

Fig. 2

Fig. 3