A SERVICE OF

logo

Open as PDF
next previous
-
11 -
8. Drill the remaining holes through the
side mounting brackets into the griddle
chass
is. Insert and tighten screws as
shown in Fig. 7. Repeat procedure for
the other side of the assembly.
9. Drill holes with 5/32” bits from the rear of
the side mounting bracket into the back
mounting bracket and install wall
spacer
with (4) 10-24 x ½”
screws as shown in
Fig. 8. Repeat procedure for the other
side of the assembly.
Wall Spacer
10. Install one bottom support bracket every
two feet of griddle width between griddle
top mounting points as needed for
additional support. Bott
om support
brackets should be flush with bottom of
griddle chassis and back mounting
bracket. Drill two holes with 5/32” bits
and attach with 10-
24 x 2” screws as
shown in Fig.9 to the back mounting
bracket. Repeat for each bottom
support bracket needed.
Cutaway
side view
Fig. 7
Fig. 8
Fig. 9
Bottom support
bracket