Teledyne API Model 401 O
3
Photometric Calibrator Instruction Manual, 01124, Rev. J2
Table 4-1: Setup Variables
Button Sequence Function Default Limits
SETUP-EVNT-WAIT
Zero cal. duration
Span cal. duration
15 min.
15 min.
1-20 min.
1-20 min.
SETUP-EVNT-TIME Cal. time-of-day 23:30 00:00-23:59
SETUP-EVNT-ASEQ Auto. Multipoint cal. enable OFF OFF/ZS/Z2S/Z5S
SETUP-EVNT-SHFT Auto check shift 0 min.
± 60 min.
SETUP-COMM-BAUD RS-232 baud rate 2400 baud 300, 1200, 2400
SETUP-COMM-ID Analyzer ID number 0000 0000-9999
SETUP-MISC-O3-SLPE Slope adjust parameter 1.00 0.85 - 1.15
SETUP-MISC-O3-GEN-ADJ O
3
GEN lamp setup/adjust OFF ON - OFF
SETUP-MISC-O3-GEN-CAL O
3
GEN calibration OFF ON - OFF
SETUP-MISC-O3-GEN-
MODE
Feedback mode selection BNCH
SETUP-MISC-O3-OFFS Offset adjust parameter 0.0
± 1000.0
SETUP-MISC-DARK-VIEW Dark current offset 0 mV 1000 mV
SETUP-MISC-CLK-TIME Current time-of-day 00:00 00:00 - 23:59
SETUP-MISC-CLK-DATE Current date 01 JAN 00 31 DEC 99
SETUP-MISC-CLK-ADJ Clock speed adjust 0 sec/day
± 60 sec.
SETUP-MISC-D/A-RNGE D/A output range 500 ppb 100-10000
SETUP-MISC-D/A-OFFS D/A offset setting 0 mV
± 500 mV
SETUP-MISC-MORE-FLT Fault LED timeout 5 min 0 - 10 min
SETUP-MISC-MORE-UNITS O
3
conc. units ppb ppb/ppm/ug/mg
SETUP-MISC-MORE-TCHN TEST to analog output OFF OFF-ON
SETUP-PASS Cal. password enable ON OFF-ON
SETUP-CFG-LIST Software configuration O
3
CALIB. Display
4-7
