A SERVICE OF

logo

Open as PDF
next previous
15
Rev B
SATO SERVICE MANUAL
CX Series Printers
SECTION 1 - GENERAL INFORMATION
LOWER THE PRINT HEAD
AND PRESS DOWN FIRMLY
ON BOTH HEAD LATCHES
TO LOCK THE PRINT HEAD
IN POSITION
1-6 Printer Setup
Loading Ribbon (Continued)
TURN RIBBON TAKE-UP
KNOB CLOCKWISE TO
ELIMINATE RIBBON
SLACK
Selecting the Label Sensor Type
CX200 printers support Eye-Mark, gap, or notch label sensing. The printer must be
set for the proper sensing method. If you are using label printing software, it should
provide a means to set up these parameters. See your software documentation for
details. If you are writing your own software or controlling the printer using direct
commands, you must use printer commands to set up the print mode and sensing
method. Refer to the programming manual.