A SERVICE OF

logo

Open as PDF
next previous
46
On start
Whenthisfunctionissetto“On,”theprojectoris
automaticallyturnedonjustbyconnectingtheACpower
cordtoanoutlet.
Note:
Be sure to turn the projector off properly (see “Turning Off
the Projector” on page 19). If the projector is turned off
in the incorrect sequence, the On start function does not
operate properly.
Lamp control
Remote control
Thisprojectorprovidestwodifferentremotecontrolcodes;
thefactory-set,initialcode(Code1)andthesecondarycode
(Code2).Thisswitchingfunctionpreventsremotecontrol
interferencewhenseveralprojectorsorvideoequipmentare
operatedatthesametime.
Whentheprojectorisoperatedin“Code2,”boththe
projectorandtheremotecontrolmustbeswitchedto“Code
2.”
To chan�e the code for the projector:
Selecteither“Code1”or“Code2”inthisSettingMenu.
To chan�e the code for the remote control:
PressandholdboththeMENUandIMAGEbuttonstogether
formorethan5seconds.Afterchangingthecode,make
suretheremotecontroloperatesproperly.
Remote control
Pressandhold
MENUand
IMAGEbuttons
formorethan5
seconds.
Youcanchangethebrightnessofthescreen.
High……BrighterthantheNormalmode
Auto……Brightnessaccordingwiththeinputsignal
Normal …Normalbrightness
On start
Note:
• When different codes are set on the projector and on the
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the code
on the projector.
• If the batteries are removed from the remote control for a
long period of time, the remote control code will be reset.
Settin�
Note:
Lamp mode cannot be changed for a while after
turning on the projector. Lamp needs some time to
stabilize after the power is turned on. Stored lamp
mode will be active after the lamp is stabilized.