7
* depending on model
Before ironing for the first time fill iron and allow to heat.
The iron should be allowed to emit steam for at least 1 minute
to remove any impurities.
Press the burst of steam button a few times prior to ironing.
This should also be done if iron isn’t used regularly.
8 • High Pressure Steam
Your iron is fitted with the new High Pressure
Steam system. This technology generates higher
steam pressure to enable the steam to penetrate
much faster and further into the fabric. This way
you get excellent results from your ironing.
The steam is emitted in frequent bursts rather
than continuously. The pressure generates may
cause a slight noise. This is not a technical fault!
9 • Burst of Steam
This feature is ideal for removing stubborn
wrinkles or pressing in sharp creases.
When the temperature control is set to a steam
setting (•• or •••) the burst of steam can be used.
Press the button to generate a burst of steam.
Leave an interval of at least four seconds
between bursts.
10 • Vertical Steam
This feature is ideal for hanging clothes, drapes,
curtains, etc.
When the temperature control is set to a steam
setting vertical steam can be used.
To use feature, hold iron vertically with the tip
tilted forward slightly.
Press the burst of steam button repeatedly while
moving iron up the garment from bottom to the top.
If vertical steam output starts to decrease tilt iron
forward to a horizontal position and then back to
vertical to continue.
