A SERVICE OF

logo

12
* depending on model
Over use of burst button.
Distilled or softened water
being used.
Overfilled.
Auto-off has engaged*.
Starch use.
Burnt material. Ironing at
too high a temperature.
Priming may be necessary
on first use.
Allow more time between
each burst.
See section "Water
Recommendations”.
Switch to spring water or
mix tap water with spring
water. Do not fill past max
line on tank. Be sure to
close filling inlet.
Move iron or shake gently
to reactivate.
Spray reverse side of
fabric and allow starch to
penetrate.
Be sure to set
temperature according to
fabric being ironed.
Fill with water.
Hold cold iron
horizontally. Place finger
over the spray nozzle to
create a vacuum. Press
the spray button 4 to 5
times. Remove finger
from nozzle, press spray
button a few more times.
If troubleshooting does not assist, before consulting the retailer
regarding their return/exchange policy, please telephone
consumer service at 781-396-0600.
Iron is leaking.
The Auto-off light is
flashing
Build-up on the
soleplate.
Spray function does not
work.
DZ9080 US 1103898398 10/05/06 11:00 Page 12