2-14 Raynger 3i Series Operator’s Manual
2.4.5 LOG Loop–To Measure and Store Temperature
The LOG loop is for making temperature measurements and storing them in the data
logger locations. Figure 2-7 illustrates the LOG loop.
To use the modes and functions of the LOG loop, do the following:
1. Point the instrument at the target.
2. Pull the trigger and press the RUN/LOG button, if necessary, so that the LOG icon
is activated.
3. Press the ▲ or ▼ buttons to select the LOG location number where you want to
store the measurement. To change the emissivity setting for that location, press
the MODE button and use the ▲ or ▼ buttons .
4. Press the laser button to activate the laser (if equipped with laser sighting).
5. Carefully aim using the laser or scope.
6. Read the temperature from the display.
