61
Note:
When you try to store more than 100 talk group
ID’s in a bank,
Memory
full!
appears. Clear some
talk group ID’s in order to store new ones (see “Clearing
Talk Group ID’s” on Page 62).
Follow these steps to manually store talk group ID’s or to
edit a stored ID.
1. Press
PGM
.
2. Press
TRUNK
.
3. To select the bank you want to store the ID to, press
FUNC
, then press or .
4. Press
MODE
to select
LT
,
MO
, or
ED
.
5. Enter the talk group ID and press
ENTER
. If neces-
sary, use the decimal point for a hyphen.
Note:
If you made a mistake in Step 4,
Invalid
ID
. appears and the scanner beeps when you press
ENTER
. Start again at Step 3.
6. Press
TEXT
and enter the text tag for the ID and
press
ENTER
.
7. To store the next ID memory in sequence, press
and repeat Steps 4 and 5 to enter more IDs.
8. Press
SCAN
to start scanning.
Talk Group ID Hold
You can set your scanner to follow a trunking signal,
which you wish to track while scanning. Hold down
TRUNK
more than 2 seconds.
ID
hold
ON.
appears on
the display.
To release
ID
hold
ON.
, press
SCAN
or
TRUNK
.
20-522.fm Page 61 Friday, September 17, 1999 12:46 PM
