To stop the program temporarily, press the Stop
button. The Time/Incline/Segment Time display
will begin to flash. To restart the program, press
the Start button or the Speed L button. To end the
program, press the Stop button, remove the key,
and then reinsert the key.
4
Follow your progress with the displays.
Refer to step 5 on page 10
Ei
Measure your heart rate, if desired.
See step 6 on page 11
fl
When the program is completed, remove the
key from the console.
When the program has ended,
make sure that
the incline of the treadmill is at the lowest set-
ting.
Next, remove the key from the console and
put it in a safe place
Note: If the displays and
various indicators on the console remain lit
after the key is removed, the console is in the
"demo" mode. Refer to page 20 and turn off the
demo mode.
When you are finished using the treadmill, move
the on/off switch near the power cord to the off
position and unplug the power cord.
The two profiles on the left side of the console
show how the target heart rate will change during
the programs. The numbers above the profiles
represent percentages of your estimated maxi-
mum heart rate. (Your estimated maximum heart
rate is determined by subtracting your age from
220. For example, if you are 30 years old, your
estimated maximum heart rate is 190 beats per
minute [220— 30 = 190]. If you are 30 years old, a
target heart rate setting of 50% is equal to 95
beats per minute [50% of 190 is 95]).
HOW TO USE HEART RATE PROGRAMS
A
CAUTION
.
. If you have heart prob-
lems, or if you are over 60 years of age and
have been inactive, do not use the heart rate
programs. If you are taking medication regu-
larly, consult your physician to find whether the
medication will affect your exercise heart rate.
Follow the steps below to use the heart rate programs
Note: You must wear the optional chest pulse sen-
sor (see page 20) to use the heart rate programs.
13
Put on the chest pulse sensor.
Refer to the instructions included with the optional
chest pulse sensor.
Ei
Insert the key fully into the console.
See HOW TO TURN ON THE POWER on page
10
El
Select a heart rate program.
When the key is
/
P9nr...ta,
inserted, the
o
manual mode
will be selected.
To select one of
the heart rate
programs, press
the Program button repeatedly until one of the two
heart rate program indicators lights.
13
