1 • Read This First
1 - 6 SV60861 Rev. F
• Be certain the area in front of the wall receptacle into which the machine
is plugged is free from obstruction.
• To prevent overheating, do not cover the vent openings.
• Read all instructions before attempting to operate the equipment.
• Use this equipment only for its intended purpose.
If your stacker has an AC adapter to power the stacker:
• Use only the AC adapter designed specifically for the stacker and
shown in Ch
apter 11, Supplies and Options. Third-party AC adapters
may damage the stacker.
• To protect against electrical shock, plug the AC adapter power cord into
a pr
operly grounded wall outlet.
Do not route the AC adapter cable over sharp edges or trap it between
furniture.
Y
our DM Series™ Digital Mailing
Syste
m is designed to remain powered on
at all times. This is necessary so that the printer station can perform the
required maintenance it needs to maintain peak performance.
Your DM Series™ System has a power switch (for the location, refer to
Chapter 2, p
age 2-6) so that you can properly remove power to the system.
If you need to power off your system, you must use the power switch. When
you power of
f the system, the system immediately moves the printhead
back to the capping station to keep the printhead from drying out.
Powering off your system by any other means, such a
s a wall switch, a
power strip, or unplugging from a wall outlet, will result in higher than normal
ink consumption and could damage your mailing system.
NOTE: Always follow the specific occupational safety and health standards
for your workplace.
Important Information About Powering Off
Your DM Series™ Digital Mailing System
