A SERVICE OF

logo

Open as PDF
next previous
This completes the programming of the control unit. Unplug the Programming Cable from the back of the unit,
and store it away for the next programming session. Connect the supplied LDV cable (3 pin round to 15 pin)
from the player to the controller. At this point it is recommended that both the controller and the player have their
power shut off for 10 seconds. When they are turned back on, the DVD-204 /DVD-212 will wait 45 seconds
before sending any commands to the player. This is to ensure that the player has had time to spin up. During this
time, the red “Program” light on the back of the controller will wink. When it goes out, the player will go to its Idle
(or Attract) sequence, and the pushbuttons will be enabled. Note that the pushbuttons will only illuminate once the
player is up to speed.
Player and Programming Cable Pinouts
PC-9 Programming Cable