Black plate (7,1)
Important
! Never use force orgrip the display and the
buttons too tightlywhen removing or attach-
ing.
! Avoid subjecting thefront panel to excessive
shocks.
! Keep the front panelout of direct sunlight and
high temperatures.
! A few seconds after turning the ignition
switch to on oroff, thefront panel automati-
cally moves. When thishappens, your fingers
may become jammedin the panel, so keep
your hands away fromit.
Removing the front panel
1 Press and hold EJECT to open the front
panel.
2 Slide and remove the front panel to-
ward you.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
3 Put the front panel into provided pro-
tective case for safe keeping.
Attaching the front panel
1 Make sure the inner cover is closed.
2 Replace the front panel by clipping it
into place.
About the demo mode
This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.
Important
The red lead (ACC)of this unit should be con-
nected to a terminalcoupled with ignition switch
on/off operations. If thisis not done, the vehicle
battery may be drained.
Reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing BAND when power to this
unit is turned off while the ignition switch is
set to ACC or ON cancels the reverse mode.
Press BAND again to start the reverse mode.
<CRD4089-A/N>7
Before You Start
En
7
English
Section
01
