3.1.4 Customizing the Buttons
You can customize the flexible buttons and/or programmable feature (PF) buttons on PTs, Add-on Key
Modules, and PSs. They can then be used to make or receive outside calls or as feature buttons.
• To enter the programming mode when using a PS, refer to "Operating Instructions" for PS.
• The buttons in the table below can only be set on certain flexible buttons, as follows:
– Flexible buttons on PTs/Add-on Key Modules/PSs: all buttons can be set.
– Flexible buttons
on DSS Consoles: all buttons except CTI and Primary Directory Number
(PDN) buttons can be set.
– Programmable feature (PF) buttons: only the One-touch Dialing button can be set.
Press PROGRAM
or PAUSE.
Press PROGRAM
or PAUSE.
Press desired
flexible button.
To exit
To program
To enter the program mode
Follow
programming
input.
To continue
programming
input
OR
PROGRAM
PAUSE
OR
PROGRAM
PAUSE
Press ENTER
or STORE.
OR
AUTO DIAL
STORE
Button Programming Input
Loop-CO (L-CO)
Group-CO (G-CO)
+ CO line group no. (2 digits)
Single-CO (S-CO)
+ CO line no. (3 digits)
Direct Station Selection (DSS)
+ Extension no.
One-touch Dialing
*1
+ Desired no. (max. 32 digits)
Incoming Call Distribution Group
(ICD Group)
+ Incoming call distribution group extension no. (+
+ delayed ringing time [0–7])
*4
Message
Message for Another Extension
+ Extension no./Incoming call distribution group extension
no.
Call Forwarding (FWD)/Do Not
Disturb (DND)—Both calls
FWD/DND—Outside calls
FWD/DND—Intercom calls
Group FWD—Both calls
+ Incoming call distribution group extension no.
Group FWD—Outside calls
+ Incoming call distribution group extension no.
174 Operating Manual Document Version 2008-10
3.1.4 Customizing the Buttons
