44
First Time Setup—Continued
TV Format Setup
Here you can specify the TV format used in your area.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “0. Initial
Setup,” and then press [ENTER].
The Initial Setup menu appears.
(Menus vary depending on country.)
3
Use the Up and Down [ ]/[ ]
buttons to select “f. Sp Imped-
ance,” and then use the Left and
Right [ ]/[ ] buttons to select:
4 ohms: Select if the impedance of any
connected speaker is 4 ohms
or more, but less than 6 ohms.
6 ohms: Select if the impedances of all
connected speakers are
between 6 and 16 ohms.
4
Press the [SETUP] button.
The setup menu closes.
RECEIVER
ENTER
ENTER
ENTER
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “0. Initial
Setup,” and then press [ENTER].
The Initial Setup menu appears.
(Menus vary depending on country.)
3
Use the Up and Down [ ]/[ ]
buttons to select “h. TV Format,”
and then use the Left and Right
[ ]/[ ] buttons to select:
Auto: Conforms with the video
input signal.
PAL: Select if the TV system in
your area is PAL.
NTSC: Select if the TV system in
your area is NTSC.
4
Press the [SETUP] button.
The setup menu closes.
RECEIVER
ENTER
ENTER
ENTER