ES 1220n Menu Functions • 207
IP ADDRESS
SET
AUTO
MANUAL
Change this to Manual to specify the IP
address through the front panel.(see
next entry) Required for non-DHCP
networks.
IP ADDRESS xxx.xxx.xxx.xxx
Default =
192.168.100.100
Current assigned IP address. To
change:
• Press ENTER.
• Use +/– keys to increment first octet.
• Press ENTER to move on to the next
octet.
• Use +/– keys to increment second
octet.
• Press ENTER to move on to the next
octet.
• Use +/– keys to increment third octet.
• Press ENTER to move on to the last
octet.
• Use +/– keys to increment 1st octet.
• Press ENTER to register the new
address.
SUBNET MASK xxx.xxx.xxx.xxx
Default =
255.255.255.000
Current assigned subnet mask. To
change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx
Default =
192.168.100.254
Current assigned gateway address. To
change, proceed as above.
INITIALIZE
NIC?
[EXECUTE] Initializes the network card.
WEB/IPP ENABLE
DISABLE
Enables or disables Web config. facility
and Internet Printing Protocol.
This item will not appear in the menu if
TCP/IP is set to DISABLE.
TELNET ENABLE
DISABLE
Enables or disables Telnet config.
facility.
This item will not appear in the menu if
TCP/IP is set to DISABLE.
Network Menu (continued)
Note: Factory default settings are shown in bold.
Item Settings Explanation
