Safety
1-4
Part 7119745C
E 2007 Nordson Corporation
MiniCure 08-07
Fire Safety
To avoid a fire or explosion, follow these instructions.
S Use only those inks and varnishes that cannot form explosive
atmospheres when heated by the lamp head (i.e. inks and varnishes
whose safety data sheets specify a flammable limit must not be used).
S Do not smoke, weld, grind, or use open flames where flammable
materials are being used or stored.
S Provide adequate ventilation to prevent dangerous concentrations of
volatile materials or vapors. Refer to local codes or your material MSDS
for guidance.
S Do not disconnect live electrical circuits while working with flammable
materials. Shut off power at a disconnect switch first to prevent
sparking.
S Shut down all equipment immediately if you notice sparking or arcing.
Do not restart the equipment until the cause has been identified and
corrected.
S Know where emergency stop buttons, shutoff valves, and fire
extinguishers are located. If a fire starts, immediately shut off the
system and exhaust fan.
S Clean, maintain, test, and repair equipment according to the instructions
in your equipment documentation.
S Only use replacement parts that are designed for use with original
equipment. Contact your Nordson representative for parts information
and advice or refer to the spares list in this manual.
