46D0232
14
SS38 Direct Vent Gas Stove
4. Apply a bead of non-hardening mastic around the
outside edge of vent cap. Position the vent cap in the
center of the 7Z\x" (190 mm) or 9Z\x" (241 mm) hole on the
exterior wall with the word “UP” on the vent cap facing
up. Insure proper clearance of 1" to combustibles is
maintained. Attach the vent cap with four wood screws
supplied. Figure 12.
Replace the wood screws with appropriate fasteners
for stucco, brick, concrete, or other types of siding.
VO584-100
Vent Opening
2/99 djt
9B\,”
(244 mm)
Min.
Stove Hearth
Framing Detail
7Z\x”
(190 mm)
Stove Hearth
FP2293
Figure 11 -
Vent Opening Requirements
9B\,”
(244 mm) Min.
HOT
FP1955
horizontal vent cap
Vent Cap
Wood ScrewApply Mastic to
All Four Sides
FP1955
Figure 12 -
Install Horizontal Termination
For vinyl siding, stucco, or wood exterior use vinyl siding
standoffs between vent cap and exterior wall. The vinyl
siding standoff prevents excessive heat from melting the
vinyl siding material. Bolt the vent cap to the standoff. Apply
non-hardening mastic around outside edge of the standoff
instead of the vent cap assembly. Use wood screws pro-
vided to attach the standoff. Figure 13
HOT
FP1956
vinyl siding standoff
Cut Vinyl Siding
Away to Fit
Standoff
Standoff
Apply
Mastic to
All Four
Sides
Nut
Wood Screw
Bolt
Termination
FP1956
Figure 13 -
Install Vinyl Siding Standoff and Termination
5. Slide the wall thimble over the vent pipe before con-
necting the horizontal run to the vent cap. Figure 14
6. Carefully move the stove with vent assembly attached
toward the wall and insert the vent pipe into the hori-
zontal termination. The pipe overlap should be a mini-
mum of 1Z\v" (32 mm). Apply silicone to the outer pipe
connection. Fasten all vent connections with screws
provided.
7. Slide the wall thimble against the interior wall surface
and attach with screws. Figure 14
Interior Wall
Surface
Firestop
Vent Cap
(Horizontal
Termination)
Screw
Horizontal
Vent Pipe
FP1957
Figure 14 -
Install Firestop on Horizontal Vent Pipe
