Lowrance - LVR-880 Operation Instructions22
Tip: If you are in the NAV big number screen, just turn the Channel Select knob to immedi-
ately access the Waypoint List. Select the new waypoint and press ENT.
3-1-4 Go to Nearest Waypoint (NEAREST WP)
MENU SELECT
WAYPOINT
BACKLIGHT
BUDDY LIST
WAYPOINT
WP LIST
NEAREST WP
TEMP
NEAREST WP
R01W04 001
98
R01W01 003
136
Note: A valid GPS signal must be received to see this selection.
Select WAYPOINT then NEAREST WP.1.
Press ENT to display the nearest waypoint with distance and bearing from your current 2.
position.
Other waypoints are listed in increasing distance from your current position.
Press ENT to set the nearest waypoint as the active waypoint OR move the cursor to 3.
another waypoint and then press ENT.
The chosen waypoint is shown on the bottom line of the LCD.
3-1-5 Go to Temporary Waypoint
MENU SELECT
WAYPOINT
BACKLIGHT
BUDDY LIST
WAYPOINT
WP LIST
NEAREST WP
TEMP
TEMP
TEMP1
TEMP2
TEMP1
GO
TEMP EDIT
DELETE
Select WAYPOINT then TEMP.1.
Your temporary waypoint list is displayed. There are 3 choices for quick access. 2.
Select the temporary waypoint to go to. Press ENT. 3.
Press ENT to set the temporary waypoint as the destination waypoint. It is immediately 4.
shown on the bottom line of the LCD.
Tip: Hold down MOB and release before the 3 second countdown completes. Your current LL
position is stored in TEMP1 to TEMP3 in the waypoint list. If the list is full, a message appears
asking if the oldest location can be overwritten:
TEMP WP FULL
DELETE TEMP1?
YES
NO
