VP-81SIDN - Operating the VP-81SIDN Remotely
Click, hold and move the slider up (higher) or down (lower) to
adjust the output volume (see Section 9.2)
Click to mute/unmute the output volume (see Section 9.2)
Note: When a change is made on the device (for example, a different output is
selected), the change is reflected almost immediately in the main window of the
Step-in Software, and visa versa.
Figure 13 shows a typical input button.
Figure 13: Typical Input Button
The following table describes the Button characteristics.
Input (1–10) or output (1–2) channel number
User-selectable button label, Admin only (see Section 9.1.1)
Indicates the status of the connection and signal on the
channel:
TIMEOUT—no cable
MUTE— cable present, no signal detected
WAIT— cable and signal present but channel is not selected
ACTIVE—cable and signal present and channel is selected
(only one channel at a time)
User-selectable icon selected to be displayed on the button,
Admin only (see Section 9.4)
Video input type: VGA, HDMI, DP, DVI
Video resolution, i=interlace/p=progressive, refresh rate
Slider for adjusting the priority (1, lowest–10, highest) of the
input, Admin only (see Section 9.3)
