Main menu - Settings
After calling up the menu you will see the following
display:
If you do not have a meter for adjusting your reector,
you can use the sat nder as an alignment aid. However
the sat-nder is not a complete substitute for a meter.
The individual items are selected using the
buttons. Changes to the current settings can be made
using the
buttons or the numeric keypad.
Satellite
Select the satellite on which the transponder to be tested is located. Make sure your reception system is aligned to
this/these selected satellite(s).
Frequency
Use the
buttons (transponder frequency already saved) or the keypad (transponder frequency not yet saved)
to select the transponder frequency to be tested. At the bottom right of the screen display, the receiver shows the
current signal strength and signal quality of the selected transponder.
The “DVB Type”, “FEC”, “Polarization” and “Symbol Rate” options only need to be specied if the transponder
has yet to be saved.
DVB type
Select here whether standard channels (DVB-S (SD)) or HDTV channels (DVB-S2 (HDTV)) should be received from
the desired transponder.
After calling up the menu you will see the following
display:
You can choose between various different menus:
- Sat Finder
- Tuner Conguration
- Edit Satellites
- Edit Transponders
Use the
buttons to select the desired menu and
conrm your selection using the
button.
