Switching On for the First Time
16
OSD On Screen Display
Switching on with BZD 30
1. Switch on the TV set and the receiver.
- Switch the receiver into the operating mode with the
(Stand-by) button (the LED switches to green).
2. Switch the TV set to AV mode if the TV set does not switch over
by itself.
3. To activate the power supply for the antenna, please perform the
following steps with the receiver remote control:
- Press the
button to reach the main menu.
- When you are in the main menu please select the "Installation"
sub-menu with the
buttons and confirm with the
button
- Now go with the
buttons to "Network Configuration“
and again confirm with
.
- Press the
button once again to reach the "Power" subitem.
- Under this item you must now change the selection of the supply
voltage with the
buttons from "Off" to "On" (see figure).
- The antenna is now supplied with the operating voltage of 5 V.
- You return to the TV mode by pressing
four times.
