Surface Cooking 8
Automatic Oven Turn Off Option
The oven will automatically turn off after 12 hours, if you
accidentally leave it on. You can deactivate this feature, if
desired.
Surface Controls
To Eliminate 12 Hour Turn Off
1. Press the Clock pad and hold for three seconds or until
"12" appears in the display. The indicator word TIME will
flash in the display.
2. Press any number pad until 8888 appears in the display.
Current time of day will reappear in the display after four
seconds.
To restore: Press the Clock pad and hold for three seconds
or until 8888 appears. Press" 1" number pad. "12" will appear
briefly in the display followed by the current time of day.
Oven Temperature Adjustment Option
If you think the oven should be hotter or cooler, you can adjust
it yourself. To decide how much to change the thermostat, set
the oven temperature 25°F higher or lower than the tempera-
ture in your recipe, then bake. The results of the "test" should
give you an idea of how much to adjust the thermostat.
Pilotless Ignition
Pilotless ignition eliminates the need for a constant standing
pilot light. Each surface burner has a spark ignitor. When
cleaning around the surface burner use care. If cleaning cloth
should catch the ignitor, it could damage it preventing igni-
tion.
If the surface burner does not light, check if ignitor is broken,
soiled or wet. If clogged, clean the small port beneath the
ignitor using straight pin.
CAP
To adjust the thermostat:
1. Press the Bake pad.
2. Enter 550 ° by pressing the number pads "5, 5, 0".
3. Press and hold the Bake pad for several seconds until 0°
appears in the display.
4. Press any number pad to change the temperature. Each
time a pad is pressed, the temperature changes by 5°E
Press repeatedly to reach +35°E Continue pressing to
reduce the temperature up to -35°E
5. When you have made the adjustment, press the Stop/Clear
pad and the time of day will reappear in the display. The
oven will now bake at the adjusted temperature.
It is not necessary to readjust the oven temperature if there is
a power interruption. This adjustment will not affect broil or
clean temperatures.
PORT BELOW IGNITOR
Surface Control Knobs
Use to turn on the surface burners. An
infinite choice of heat settings is available
from Lo to Hi. At the Hi setting a detent
or notch may to felt. The knobs can be set
on or between any of the settings.
Graphics to the left of the knob identify which burner the
knob controls. For example, the graphic below shows the
right rear burner location. 1_
