Tools Required: 3/16” Allen wrench, 5/32” Allen wrench.
NOTE: This procedure can be completed by one person, although having a second person is helpful when installing the new backrest. SAVE ALL PARTS FOR USE DURING REASSEMBLY.
1. Remove the pads from the chair (Fig.1).
2. Fully recline the chair (Fig.1).
3. Using a 3/16” Allen wrench, remove three screws from the inner side panel, then remove the side panel (Fig.2).
4. Using a 3/16” Allen wrench, remove two screws from the metal plate on the inside of the arm (Fig.3).
5. Using a 5/32” Allen wrench, remove four screws from the outside of the legs (Fig.4).
6. Place a sturdy object underneath the chair, then remove the legs from the chair (Fig.5).
REMOVING THE LEGS
1
SERVICE LEVEL: 2
July 18, 2012
TIGHTENING THE LEG SCREWS
PC-2/6/075/095
(Fig.1)
It is imperative that Human Touch
®
products are repaired in a manner that ensures product safety and regulatory compliance and that is
fully consistent with the practices used during the manufacturing process. Therefore, Human Touch requires that all product repairs are
performed using only factory-new parts and in accordance with these repair instructions. Failure to adhere to these instructions voids the
product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
(Fig.3)
(Fig.4)
(Fig.2)
(Fig.5)
