Table 7-2 Mopier Messages,
continued
If the following errors persist, call your HP-authorized service provider.
Message Description Recommended Action
61.x PRINTER ERROR
CYCLE POWER
The mopier encountered a parity
error when accessing internal
RAM or some SIMM memory in
slot
x
.
Switch the mopier OFF and
then ON (data stored in
mopier will be lost). If the
error is still present, first
verify that the SIMM board is
correctly installed. Switch the
mopier ON. If the error is still
present, switch the mopier
OFF and remove the SIMM
board. Switch the mopier
back ON. If the error
message does not appear,
the problem is on the SIMM.
See Appendix C, “Memory
and Personality SIMM
Installation,” for more
information.
0: Internal memory
1: SIMM slot 1
2: SIMM slot 2
3: SIMM slot 3
4: SIMM slot 4
62.x PRINTER ERROR
CYCLE POWER
The mopier identified a CRC error
while checking its memory.
x
refers to the memory the mopier
was checking when it encountered
the error.
Switch the mopier OFF and
then ON (data stored in
mopier will be lost). If the
error is still present, first
verify that the SIMM board is
correctly installed. Switch the
mopier ON. If the error is still
present, switch the mopier
OFF and remove the SIMM
board. Switch the mopier
back ON. If the error
message does not appear,
the problem is on the SIMM.
See Appendix C, “Memory
and Personality SIMM
Installation,” for more
information.
0: Internal memory
1: SIMM slot 1
2: SIMM slot 2
3: SIMM slot 3
4: SIMM slot 4
64 PRINTER ERROR
CYCLE POWER
The mopier identified a scan
buffer error.
Turn the mopier OFF then
ON again.
65 PRINTER ERROR
CYCLE POWER
The mopier identified a dynamic
RAM controller error.
Turn the mopier OFF then
ON again.
Continued on the next page.
7-44 Maintenance and Troubleshooting EN
