24 Genie GS-2668 RT & Genie GS-3268 RT Part No. 82233
Operator's Manual Second Edition · Third Printing
Fall Protection
Personal fall protection equipment (PFPE) is not
required when operating this machine. If PFPE is
required by job site or employer rules, the following
shall apply:
All PFPE must comply with applicable
governmental regulations and must be inspected
and used in accordance with the manufacturer’s
instructions.
OPERATING INSTRUCTIONS
Auto Level Outriggers
(if equipped)
These instructions apply to machines with the
black auto level outrigger control box.
1 Position the machine below the desired work
area.
2 Pull out the red Emergency Stop
buttons at the ground and platform
controls.
3 Push and hold the auto level button.
4 Activate the outrigger up/down toggle switch in
the down direction.
Result: The outriggers will extend and level the
machine. A beep will sound when the machine
is level.
The red indicator light above the lift symbol on the
outrigger control panel comes on when one but not
all outriggers are down. All drive and lift functions
are disabled.
The light turns off when all outriggers are in firm
contact with the ground. The drive function is
disabled while the outriggers are down.
To control individual outriggers
1 Push and hold the outrigger function
enable button.
2 Push and hold an outrigger
button.
3 Activate the outrigger up/down
toggle switch in the desired
direction to level the machine.
Positioning machine on a slope
When setting the machine up on a slope, the steer-
end outriggers must be lowered first.
