A SERVICE OF

logo

Open as PDF
next previous
7
2. Installing a Hard Drive Into Your Enclosure:
a. Connect your 3.5” hard drive (not included) to the 4-Pin Power Connector and IDE connector on the Hard Drive
Tray.
b. Mount your hard drive to the Hard Drive Tray with two of the enclosed hard drive mounting screws.
c. Inside your Enclosure you will notice an LED Power Cable, arrange the cable so the connector end is outside of
the enclosure and then carefully begin to slide the Hard Drive Tray, with your hard drive attached, back into
your Enclosure (NOTE: stop sliding the Hard Drive Tray in once your get to the chipset board portion of the Hard
Drive Tray and proceed to the next step).
d. Connect the LED Power Cable to the LED Power Connector on your Hard Drive Tray.