A SERVICE OF

logo

To test the impedance of the entire speaker system, first disconnect the speaker
wires from the amplifier and then measure the impedance from the disconnected
wires, as shown below.
Impedance Test Points
Captive Screw
Connector
Test Points
+
_
_
+
To next speake
r
Red Wire (+) disconnected
from Amplifier
Black Wire (-) disconnected
from Amplifier
Amplifier
ATTENTION: Disconnect the speaker system from the amplifier before
performing this test, otherwise you may damage the test meter.
• Wiring a Single Speaker:
Connect the wires to the captive screw connector of the speaker, as shown below.
Be sure to tighten the screws.
Speaker 1
+
_
_
+
(Red)
(Black)
Power Amplier
SF 26X User Guide • Installation 8