Configuring the printer Configuring the printer
3-17 3-18
+/- 1 = +/- / " = +/- 0,42 mm
1
60
+/- 2 = +/- / " = +/- 0,85 mm
2
60
+/- 3 = +/- / " = +/- 1,27 mm
3
60
+/- 4 = +/- / " = +/- 1,69 mm
4
60
+/- 5 = +/- / " = +/- 2,12 mm
5
60
+/- 6 = +/- / " = +/- 2,54 mm
6
60
+/- 7 = +/- / " = +/- 2,96 mm
7
60
+/- 8 = +/- / " = +/- 3,39 mm
8
60
+/- 9 = +/- / " = +/- 3,81 mm
9
60
+/- 10 = +/- / " = +/- 4,23 mm
10
60
+/- 11 = +/- / " = +/- 4,66 mm
11
60
+/- 12 = +/- / " = +/- 5,08 mm
12
60
+/- 13 = +/- / " = +/- 5,50 mm
13
60
+/- 14 = +/- / " = +/- 5,93 mm
14
60
+/- 15 = +/- / " = +/- 6,35 mm
15
60
+ 16 = + / " = + 6,77 mm
16
60
- CUTTING V-POS - TRACT.FF-MODE (Tractor Form Feed Mode)
This parameter can be used to compensate mechanical tolerances which BLANK PAGES means, every Form Feed sent to the printer will be
may cause a misalignment between the perforation edge of a continuous executed.
form and the tear-off position.. If you set NO BLANK PAGES, only a Form Feed before printable
The range within which variations can be met is - / " to + / ", where "-"
15 16
60 60
is up the page and "+" is further down the page.
The following table shows the possible values in inch and millimetres. - Language
- Uni-Direct.CMD
If NO is selected, commands for uni-directional printing will be ignored.
The default setting of YES means that commands will be carried out to
switch from bi-directional to uni-directional or vice versa.
characters will be executed, that means blank pages will be ignored.
Special Sub-Items under INSTALLATION
The operator panel may display its messages in three languages. Select
one out of the following: ENGLISH, DEUTSCH, FRANCAIS.
- RESTORE SET UP
With this function all settings of the last SAVE procedure will be restored.
- RECALL FACTORY
All standard settings of the firmware will be restored. The contents of Page
Counter and the Paper-in Adjust will not be changed. Use the function
SAVE if the standard settings shall be active after power off/on.
