EPL-N2700 Revision A
Product Description Panel Operation 38
1.4.2.2 User Setting Items which are not include in the
Setting Menu
The items shown below are not included in the setting menu but can be
set by users. The values set by the users are not cleared by the
initialization through the control panel.
1.4.2.3 Setting Item Description
This section provides the information on the product-specific setting
item.
MP Tray Size
“Auto” is added and the North American version automatically detects
LT, HLT, LGL, EXE, GLG, GLT, and B paper sizes, while the versions
for areas other than North America detect the A3, A4, A5, IB5, LTR,
LGL, and F4 paper sizes. When “Auto” is selected, the following
conditions should be considered:
If the edge guide is set to any position other than automatic
selectable paper sizes, the paper size loaded is detected A3.
The automatically selected paper size is shown in Status Sheet and
EJL status.
MP Type
Selects the paper type for the MP Tray.
If “Paper Source” is set to “Auto”, the printer automatically selects the
paper source that matches the selected paper type from the paper
sources that currently store the selected paper size.
The MP Type selected during paper source selection is only specified
with the EJL command.
In printer modes that have no specification command, operations are
the same as when “Plain” is set for “MP Type”.
The EPL-N2700 has the setting item “Paper Type”, if the “Paper Type”
is set to “Normal” and “MP Tray” is set to “Transprnc” or Letterhead”, the
MP Type is also set to the engine side.
Setting Item Setting value Default Value Setting method
PrinterName
32-byte character
string
EPL-N2700
EJL, Printer Name
Command
Device ID MFG
32-byte character
string
(Undefined) EJL
Device ID MDL
32-byte character
string
(Undefined) EJL
Device ID DES
32-byte character
string
(Undefined) EJL
Device ID CID
32-byte character
string
(Undefined) EJL
Mail Bin 1 - 10 NAME 24-byte data (Undefined) EJL
MP Tray
compensation
-0.4 mm to 4.00 mm
(in 0.5 mm steps)
0.0 mm EJL
LC1 - LC3
compensation
-0.4 mm to 4.00 mm
(in 0.5 mm steps)
0.0 mm EJL
Duplex compensation
-0.4 mm to 4.00 mm
(in 0.5 mm steps)
0.0 mm EJL
