A SERVICE OF

logo

Testing the Printer
3.
Press until STATUS SHEET appears on the display.
4.
Press D twice to print the status sheet. A sample printout is
shown below.
Printer Configuration
STATUS SHEET EPSON
Installed Memory : 3.OMbytes Controller Version : 15.04
CH Mode : AUTO-SENSE
CH Time out
: 28
Auto Continue
: OFF
Total Printed Count: 25
Standby : DISABLE
CH
:P
Mode
: LJ-2P
Version
I/F :
PARALLEL
PARALLEL (CH P)
SLCTIN
: OFF
AUTOFEED
: OFF
SERIAL (CH S) : RS232C
Word Length(bit) : 8 Baudrate(bps) : 9600
Stop Bit
:2 DTR
: ON
DSR
: OFF
CTS
: OFF
Receive Buffer
: 1kbytes
Mode Configuration
Input Tray : AUTO Font : RD-0
Copies
:l
Orientation : PORT
Sub Configuration
Form Length
: 60
Symbol Set
: Roman-S
: 17.04
BUSY Delay(µs) : 0
Parity
XON/XOFF
ENQ/ACK
: NONE
: ON
: OFF
Paper size
: LETTER
System Configuration
Top Offset
: 0
Full Print
: 0
Load Macro
: 0
Left Offset
: 0
Memory Left
: 2949Kbytes
Power On Macro : 0
Note: The status sheet prints the printer’s current settings,
including any new macro settings. See Chapter 4 for information
on macro settings.
5.
Press the
SelecType
button twice to exit SelecType.
If the status sheet does not print properly, see Chapter 7 for
troubleshooting information.
Testing and Connecting Your Printer
2-9