19
CS-4400
E
N
G
L
I
S
H
D
E
U
T
S
C
H
I
T
A
L
I
A
N
O
DESCRIPTION
(See page 18)
GB
1. OPERATOR’S MANUAL - Included with unit. Read
before operation and keep for future reference to
learn proper, safe operating techniques.
2. FRONT HAND GUARD - Guard between the front
handle and the saw chain for protecting the hand
from injuries and aiding in control of the chain saw if
the hand slips off the handle. This guard is used to
activate the chain brake which is to stop the saw
chain rotation.
3. CHOKE CONTROL KNOB - Device for enriching
the fuel/air mixture in the carburettor to aid cold
starting.
4. REAR HAND GUARD - Extension on the lower part
of the rear handle for protecting the hand from the
chain if it breaks or degrooves.
5. CLUTCH COVER - Protective cover to the guide
bar, saw chain, clutch and sprocket when the chain
saw is in use.
6. CHAIN TENSION ADJUSTER - Device to adjust
chain tension.
7. CHAIN CATCHER - A projection designed to
reduce the risk of the operator’s right hand from
being hit by a chain which has broken or derailed
from the guide bar during cutting.
8. GUIDE BAR - The part that supports and guides the
saw chain.
9. CHAIN - Chain, serving as a cutting tool.
10. SPIKED BUMPER - Devise, fitted in front of the
guide bar mounting point, acting as a pivot when in
contact with a tree or log.
11. OIL TANK CAP - For closing the oil tank.
12. FRONT HANDLE (FOR THE LEFT HAND) -
Support handle located at the front of the engine
housing.
13. STARTER HANDLE - The grip of the starter, for
starting the engine.
14. FUEL TANK CAP - For closing the fuel tank.
15. IGNITION SWITCH - Device for connecting and
disconnecting the ignition system and thus allowing
the engine to be started or stopped.
16. THROTTLE TRIGGER - Device activated by the
operator’s finger, for controlling the engine speed.
17. REAR HANDLE (FOR THE RIGHT HAND) -
Support handle located towards the rear of the
engine housing.
18. THROTTLE TRIGGER LOCKOUT - A safety lever
which must be depressed before the throttle trigger
can be activated in order to prevent the accidental
operation of the throttle trigger.
19. THROTTTLE LATCH - Device for temporality
setting the throttle in a partially open position to aid
starting.
20. SAFETY DECAL - Part Number 890345-39230
21. CYLINDER COVER - The cooling air flow grill. It
cover the cylinder, spark plug, silencer and air filter.
22. GUIDE BAR COVER - Remove device for covering
the guide bar and saw chain during transport and
other times when the chain saw is not in use.
