A SERVICE OF

logo

Installing the VoIP Intercom
Intercom Setup
Operations Guide 930181B CyberData Corporation
15
Figure 2-12. RTFM Switch Jumper
To announce an Intercom’s current IP address:
1. Install the RTFM jumper.
2. After two seconds, the IP address will be announced.
Note If you
installed the RTFM jumper, and if you press the call button for 10 seconds, the default
factory settings will be initiated.
2.2.7 Adjust the Volume
You will be only able to adjust the volume through the network configuration page.