STEP8: (SEEFIGURE8)
, AttachtheR.H.hangerbrackettothethreeholesshown
onthesideofthetractorframeusingthree3/8"x 1"hex
bolts(D).3/8"tockwashers(R)and3/8"fiatwashers.
Use3/8"nylocknuts(L)oninsideofframeifboltsinsert
freelyintoholes.Tighten.
, Repeatforotherside.
NOTE:Usespecial3/8"x 1"threadformingbolts(G)inany
holesthataretoosmallforregularbolts.
318" x 1" HEX BOLT (D)
(OR THREAD FORMUNG
BOLT (G} IFNEEDED)
318"LOCK
WASHER (R)
3/8" NYLOCK NUT (L)
(UFNEEDED)
\\
STEP 10: (SEE FIGURE 10)
, Assemble the pivot support bracket to the angle
support brackets using four 3/8" x 1" hex bolts (D) and
four 3/8" nylock nuts (L). Do not tighten yet.
Tighten the 4 bolts fastening the angle support
brackets to the hanger brackets.
Tighten the 4 bolts fastening the pivot support bracket
to the angle support brackets.
3/8" NYLOCK
NUT (L)
FIGURE 10
PIVOT SUPPORT
BRACKET
FIGURE 8
iNSTRUCTiONS FOR ALLTRACTORS
STEP 9: (SEE FIGURE 9)
, Assemble one angle support bracket to the topmost
set of holes in the hanger brackets using two 3/8" x
1" hex bolts (D) and 3/8" nylock nuts (L). Assemble
the second angle support bracket to the second from
the bottom set of holes in the hanger brackets using
two 3/8" x 1" hex bolts (D) and 3/8" nylock nuts (L).
Be sure the brackets are turned as shown. Do not
tighten yet.
X3/8" x 1
HEX BOLT (D)_
318" NYLOCK
NUT (L)
/
/
ANGLE SUPPORT
BRACKET
STEP 11: (SEE FIGURE 11)
, Assemble the two angle lock bars together as shown
in figure 6. so that a!l holes are aligned. Use one 3/8"
x 1ol/4" carriage bolt (E) and one 3/8" nylock nut (L).
Be sure to insert bolt from side indicated. Do not
tighten at this time.
, Hold the angle lock bars so that the square holes are
at the top=Insert the straight hook end of the angle
lock spring through the small middle hole in both
angle lock bars=
3/8" NYLOCK NUT(L)
%
3/8" x 1-1/4"
\CARRIAGE BOLT (E}
ANGLELOCK
BARS
ANGLE LOCK SPRmNG
FIGURE 9 FIGURE 11 (Right Hand Side View)
7
