TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(1) Hammer
(1) Adjustable Wrench (or socket set)
(1) 9/18" Open End or Box End Wrench
(1) 7/16" Open End or Box End Wrench
(1) 1/2" Open End or Box End Wrench
. Remove all parts and hardware packages from the
carton. Lay out parts and hardware and identify using
the illustrations on pages 3 and 4.
NOTE: Not all of the supplied parts and hardware will be
needed for one particular tractor. Unneeded items may be
discarded after assembly has been completed.
NOTE: Right hand (RH) and left hand (LH) are
determined from the operator's position while seated on
the tractor.
CAUTION: Do not begin assembling until
the tractor engine, muffler and exhaust
deflector have been allowed to cool off.
STEP 1: (SEE FIGURE 1)
Look under the front of your tractor. If there is a single
mower deck suspension bracket located underneath
the middle of the front axle, continue on to step 2. If
your tractor does not have a mower deck suspension
bracket underneath the middle of the front axle, skip
to step 4 on page 6 for tractors with dua! suspension
brackets.
MOWER DECK
SUSPENSmON
BRACKET
FIGURE 1
INSTRUCTIONS FOR TRACTORS WroTHSINGLE
FRONT DECK SUSPENSION BRACKET
STEP 2: (SEE FIGURE 2)
• Remove the tractor hood. Refer to your tractor owners
manual for instructions on how to properly remove the
hood.
,, Remove the browning shield from the front of the
tractor as shown. Hold onto the shield as you remove
the second bolt to prevent it from falling.
NOTE: Reinstall the browning shield before using your
tractor.
FIGURE 2
STEP 3: (SEE FIGURE 3)
, Fasten the R.H. hanger bracket (bend facing out)
to the holes indicated in the tractor frame. If there
is an engine mounting plate like the one drawn with
dotted lines, use large 1/2" flat washers (M) as shims
between the hanger bracket and the tractor frame in
the locations shown. In the front three holes use three
3/8" x 1" carriage bolts (H), two targe 1/2" washers
(M) if needed, and three 3/8" nylock nuts (L). In the
rear hole use a 5/16" x 1" carriage bolt (F), a large
1/2" washer (M) if needed, and a 5/16" nylock nut (K).
Tighten all bolts. Repeat for the LH. hanger bracket.
Reinstall the browning shield then go to step 9 on
page 7.
112" LARGE
5116" x 1" WASHER (M)
ENGINE CARRIAGE (IF NEEDED)
MOUNTING BOLT (F)
PLATE
5/16" NYLOCK]l
NUT(K) /-'_l\
3/8" NYLOCK
,uT (£ 1
FIGURE 3
